Search: smittybilt   >  

I recently asked Demco about brakes pulsing with the install of the Demco SBS Stay in Play part #SM99251 and they said this was normal if the sensitivity was cranked up too high and near the max setting. Have you set the sensitivity setting of your…

Since everything on your Roadmaster Falcon 2 tow bar still functions, it sounds like you just need the Complete Repair Kit for Roadmaster Falcon 2 and BlackHawk Tow Bars #RM-910003-60 to replace the bushings and springs. This will help you get things…

I spoke to my contact at Roadmaster and they informed me that the issue you are having is more than likely a worn out bushing. The inner arms are made of stainless steel so rust would not be the issue. In order to get the tow bar back up to speed you…

I've actually answered a similar question on this before and found: In my research I found that the grease seal you are looking for could have an inner diameter of either 2.24 or 2.12 inches and an outer diameter of 3.37 inches when measured with…

The towing mirror I would go with for your 2014 Ford Expedition EL Limited is the CIPA dual view clip-on towing mirror #11953 because it's very easy to install and has dual-adjustable mirrors. It's a universal fit towing mirror and will fit…

When installing a brake controller such as the Tekonsha Prodigy P3 Trailer Brake Controller part #90195 on your 1999 GMC Yukon you will want to run the power wire (black) from the brake controller to the battery not the fuse box. You will also want…

According to an owners manual I found from Ford for the 2006 F-150 the 12 power fuse for the 7-Way is located in spot 106 and requires a 30 amp cartridge fuse. There is also a Full ISO relay needed in spot R05. Your owners manual has a section on…

Yes, the Power Pull fifth wheel hitch was an older hitch made by the company Valley which is designed to fit the same fifth wheel rail dimensions as what the #RP58058 has.

You most likely will have a 60 degree cone. That is the most common. I included a picture that shows where the 60 and 90 degrees are being measured. It can be hard to tell with the naked eye unless you have one of each next to each other to compare.…

Yes it is that simple! To wire in a brake controller to your 2011 Chevy Colorado only requires you to wire the four wires of the controller to the 4 wires that are present under the dash of your truck. I attached an install video that shows this…

Yes, the Wheel Bolts, #RG02-020, are 1/2-20 bolts which seems to be the standard for many hubs, drums, and wheels. They also have the industry standard 60 degree cone and are fine threaded.

To change your hub bolt pattern will require you to change hubs to one that has the bolt pattern you need. You will need to know what spindle you have on your trailer. In order to do that you can either get the inner and outer bearing numbers from a…