Result: Step Support

| With the truck step inserted into a trailer hitch the support arm will sit 1-5/8 inches below the hitch receiver opening and the support arm will extend under the vehicle 22-1/2 inches from the front of the hitch receiver, when it is completely retracted under the vehicle. |

Yes, the Replacement Gear Box and B Linkage for Kwikee Electric RV Steps # LC379161 is confirmed to fit series 28 steps on your 2000 National Seabreeze Motorhome. | Does this fit a series 28...

Since the Topline Tailgate Step TS2000-01 mounts directly to the top edge of the tailgate, more than likely it will interfere with the tonneau cover on your 2017 Nissan Frontier but I have another option. ...

You are correct. The Scissor Steps # SS03 that you referenced could easily be removed from the mounting bracket that gets attached to the RV or wherever you mount it. | With regards to the #SS03 Scissor Steps,...

I took a look through all of our replacement step pads and we have nothing with these measurements. | Looking for replacement pads for kick boards that are 80 inches long. Chrome 4 inch oval - picture attached - having a hard...

The Bestop # B1614601 is a fit for a 2019 Nissan Frontier w/ 5 foot bed. As shown in step 4 of the instructions I've linked for you, the tonneau cover will indeed mount in the tracks installed into the side of the truck bed. |

If you also have the Nissan sliding bed extender, you would also need the Sliding Bed Extender Adapter Kit, # 834532006946, so the tonneau will fit. The next step down is Vanish Roll-Up Tonneau Cover, # 834532007950. |

We do not have a custom-fit replacement bumper for your Frontier but we do have other custom accessories like tube steps, grille guards, ladder racks and tonneau covers meant specifically for your truck. |...

That you have the Curt Wiring Harness with 4-Pole Flat Trailer Connector, # C56225, is the first needed step. If you have not already installed this, please note the linked installation video below for assistance. | I recently...

Once this is done you will just follow the original pairing steps again as outlined in the instructions manual (and also attached below) to set it as the rear camera. | I have a Furrion vision S observation system. I hooked...

Thank you for describing the trailer lighting issue you're having and the testing/troubleshooting steps you've taken to diagnose the cause. If I understand correctly you have a 4-pole harness such as # HM43575 which does indeed plug in to the OEM tow package wiring under the vehicle. |

The simplest troubleshooting step is to substitute either a different tow vehicle or a different trailer to see if the same problem occurs. | I have a 2009 Nissan Frontier, and when I connect my trailer using a 4 prong plug...