Where do the Relays Install with the Tow Ready Harness # 118265 on a 2014 Honda Pilot
Published 08/27/2014 >
Question:
I have installed the 7way harness in my 2014 Pilot but dont know where the relays plug in. Since the vehicle is pre-wired with the Factory Tow set up, the fuse box in the engine compartment does not have any location that would fit the relays. Is there another location for the relays? The single fuse that came with the kit fits in the fuse box. I have tested the lights without the relays and all lights and turn signals function properly. Any photos or additional diagrams would be helpful. Thanks.
asked by: Ron V
Expert Reply:
The relays install on the wiring harness itself. They install on the black connnector block, see the picture I attached that points out the relays and the connector block where the relays go.
Continue Researching
- Shop: Trailer Wiring
- Shop: Brake Controller
- Shop: Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional
- Article: Trailer Wiring Diagrams
- Video: Redarc Tow-Pro Liberty Brake Controller Installation - 2019 Toyota Highlander
- Q&A: Redarc Tow-Pro Liberty Troubleshooting Light Only Coming On When Brakes Are Applied
- Q&A: Are Relays and Fuses Included with the 2009 Honda Pilot Tow Wire Harness
- Q&A: 4-Way Flat Trailer Wiring Harness for a 2012 Honda Pilot to Tow a Small Trailer
- Q&A: Trailer Lights Not Working After Installing Wiring Harness on 2012 Honda Pilot
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
