Is There Bumper Cutting Required to Install Draw Tite Hitch on a 2014 Mazda 3
Published 12/02/2014
Question:
Is any cutting of the bumper necessary? When it is time to replace the muffler, does the hitch need to be removed?
asked by: Steve
1
Helpful Expert Reply:
There is no cutting or trimming of the rear fascia/bumper of your 2014 Mazda 3 required to install the Draw Tite hitch part # 24912. To see more install info check out the installation instructions I attached to the right.
In the unlikely event of you having to replace the muffler of your vehicle you would not have to remove this hitch.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Curt and Draw Tite Hitches for 2018 Mazda 3
- Q&A: Hitch And Bike Rack For A 2016 Mazda 3
- Q&A: Can You Carry More Than 2 Bikes Using a Class I Trailer Hitch
- Q&A: 3-Bike Rack Recommendation for 1-1/4 Receiver and Alternative-Frame Bikes
- Q&A: Recommended Trailer Hitch for 2015 Mazda 3 Sedan
- Q&A: Overall Dimensions Of The Stabilizer Jacks # TJ01RT-HD In The Stowed Position
- Q&A: Recommended Trailer Hitch For A 2016 Mazda 3 Sedan
- Article: Rooftop Cargo Carriers
- Article: Trailer Hitch Installation Tips
- Article: Trailer Hitch Receiver Sizes
- Article: How to Choose the Right Trailer Hitch Class