Availability of Red-Lens Beehive Side Marker and Clearance Light

Question

Question:

Hullo, Regarding your Beehive Side Marker and Clearance Light w/ Mounting Bracket, 1 Wire - Amberinch - Do you have it with a red lens? Thank you for your time.

asked by: Eric G

0

Expert Reply:

We do offer a red-lens Beehive LED Trailer Clearance/Side Marker Light from Optronics, their part # MCL21RB. This high-efficiency LED light features 8 diodes and can be mounted using Round Grommet # A54GB and connected using Two Wire Pigtail # A46PB. We do not have the exact bracket mount light you referenced in a red version.

The link at right will show you all round, red surface-mount clearance lights.

expert reply by: Adam R

0

Answer 1

It sounds like you are looking for the Bargman 58 series clearance light part #30-58-002 lens which is the part #34-59-012.

view full answer...

Answer 2

The "20327-02" light base is a rectangular shaped clearance light measuring 4" long x 2" wide which was made by Optronics. The light has since been discontinued along with the replacement lens but we have had customers use part…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Availability of Red-Lens Beehive Side Marker and Clearance Light

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching