Is it Possible to Run 3 of the LED Dome Light # ILL39CB to a Single Switch on a Trailer

Question:

I have a 6x10 enclosed trailer. I need to add lights could I hooked three of these lights together and run the wire to a single wall switch? Also what is the best way to get power to them after installation?

1

Helpful Expert Reply:

Yes, there is no reason you couldn't run the power wire of three of the # ILL39CB to a switch so that they would all turn on at the same time. For a switch you could use the part # D16740.

You will want to run the 3 power wires from the lights to the switch and then run a wire from the 12 volt power circuit of the trailer connector to the other side of the switch so that when you flip the switch on power is delivered to all three lights. You will need to ground the assemblies individually.

I attached an install video for the switch and an FAQ on trailer wiring for you to check out.

helpful expert reply by:
1
Jameson C

Ask The Experts a Question >>


Products Referenced in This Question


Product Page this Question was Asked From


Similar Expert Q&A Pages

See More Q&A Expert Answers >>