Replacement Handle for Trailer Jack on a 2009 Loadmaster Boat Trailer
Updated 10/08/2025 | Published 09/19/2025
Question:
I have a 2009 Loadmaster steel boat trailer that has a 2 1/2 square welded on jack that the handle fell off when going to the lake. I think it might be a Shelby jack. Is there any way to find a replacement handle for this? I have both gears so I can give you the diameter and the length of the drive section would be around 3. I have pictures I can send also. Please get back to me as soon as you can. Thank you for your looking into this for me. Respectfully, Robert
asked by: Robert E
Expert Reply:
Hey Robert!
I'm not seeing that we have any jack handles with a 3" diameter (which is what I believe you were saying), but I do see you recently purchased the Replacement Sidewind Handle Kit for Fulton XP15 Series Marine Jacks # F0933305S00. Did this fix your problem?
Bob E.
10/8/2025
HI JON, THE 3" WAS REFERENCING THE LENGH OF THE HANDLE SECTION THAT HOLDS THE GEAR. ALSO THE NEW PRESS PIN DIAMETER THAT CAME WITH THE NEW HANDLE IS TOO LARGE TO FIT INTO THE ORIGINAL GEAR THAT LOCKS IT TO THE HANDLE. I HAD TO GRIND THE GEAR PIN AREA WITH A SMALL DREMMEL SO THE PRESS PIN WOULD FIT. IT WOULD HAVE BEEN EASIER TO ORDER A NEW GEAR BUT I DON'T KNOW IF IT WOULD MATCH THE ORIGINAL LOWER GEAR... HOPE ALL THIS MAKES SENCE, BUT BOTTOM LINE IT WORKS GREAT! THANKS, BOB
Robert E.
9/25/2025
Don’t have it yet. Will let you know. Thanks!