Draw-Tite Hitch 75237 - What Is The Distance From Hitch Pin Hole To Edge Of Receiver?
Updated 09/26/2025 | Published 04/21/2025
Question:
What is the distance from the center of the hitch pin hole to the edge of the receiver tube? want to make sure this will work with my bike rack. Thanks
asked by: Steve
0
Expert Reply:
Hello Steve, thanks for getting in touch. I went to our warehouse and measured the Draw-Tite # 75237 hitch. I had 2-3/8" from the center of the pin hole to the edge of the receiver tube. I edited a picture to help illustrate.
The receiver tube measured 7-1/2" long overall.
I hope this helps. Feel free to reach out if there is anything else you need.
expert reply by:
Jesse M
0
75237 Measurements
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended 2 Inch Trailer Hitch Receiver For 2009 Toyota Sienna For Best Ground Clearance
- Q&A: Comparing Pacbrake to Firestone and Air Lift Air Bags
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended Best Trailer Hitch Receiver for Ground Clearance on 2018 Toyota Sienna
- Q&A: Is The Ground Connection Incorporated Into The Plug On The Curt T-Connector C53VV?
- Article: How to Measure for Trailer Hitch Drop
- Article: Rooftop Cargo Carriers
- Q&A: Recommended Hitch w/ Best Ground Clearance for a 2019 Toyota Sienna
- Q&A: Air Bag Suspension System Options and Rear View Camera for a 2017 Toyota Sienna
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Jesse M.
9/26/2025
Hey Steve, did the measurement work out for your bike rack? I'd love to know if it fit well, as it could help others with similar setups.