Availability Of Trailer Jack with 2" diameter Outer Tube
Updated 02/03/2026 | Published 07/27/2024
Products Featured in This Question
Question:
We need to replace the tongue jack for our camper 2002 Viking Legend. The outer diameter to fit into the welded mount is less than 2inch for the outer tube. I was looking at the bulldog 1500520317 but it appears too big to fit the mount. I will include pics for reference. Any suggestions?
asked by: Mimi
(click to enlarge)
(click to enlarge)
(click to enlarge)
Expert Reply:
The Bulldog # BD1500520317 has a 2-1/4" outer tube diameter, so if your jack opening is less than 2" this isn't going to work, unless you can increase the opening for your bracket to fit a 2-1/4" tube.
The only jack we offer that has a smaller outer tube is the Dutton-Lainson # DL22530 which has a 2" outer tube.
Based on your pictures though, I'd recommend cutting that bracket off the frame and having the bracket # P9012-00 welded on so you can use the new jack # FTJ120W0301
Product Page this Question was Asked From
Bulldog Round Jack - No Mount - Sidewind - 15" Lift - 2,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- Side-Mount Jacks
- Sidewind Jack
- 1001 - 2000 lbs
- Manual Jack
- 15 Inch Lift
- No Wheel or Foot
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic
- Article: How to Change a Trailer Tire
- Q&A: Replacing Lippert Equa-Flex Equalizers With MORryde CRE3000 Equalizers
- Q&A: Power Inlet Needed To Add Shore Power To An Enclosed Trailer
Samuel C.
2/3/2026
Hey, how did things turn out with the new jack setup for your Viking Legend camper? Did the welded bracket and Fulton jack end up fitting the way you wanted? Your update could make it easier for others working with older camper frames.