Correct Replacement Anti-Scuff Pads for a Yakima Mako Kayak Carrier

Question

Question:

We have older Yakima Mako kayak saddles. Do you sell just the protective felt that adheres to saddle? If a Mako felt pad is not available, do you sell just the protective felt pads for the Yakima Deck Hand saddle?

asked by: Bob G

0

Expert Reply:

Yes we have exactly what you're looking for, for your older Yakima Mako Kayak saddles. What you're wanting is the Replacement Anti-Scuff Pad for Mako and Mako Aero Saddles # Y04027.

This kit contains two felt pads, and will work with both the Mako saddles, and the Mako Aero saddles.

expert reply by: Bryce D

0

Answer 1

Hey Ronda, I checked with Yakima and yes the Replacement Rubber Saddle Pad part #Y35KV that you referenced will work on the Yakima Mako saddles you have now. How long have you had the Mako saddles?

view full answer...

Answer 2

Based on your picture it appears that you have the TLC Saddles made from 1986 to 1999. We have a few replacement parts that will fit these cradles: 1) Replacement 5/16" Hex Key Set for Yakima Roof Mounted Carriers - (QTY 4) Item #Y8810041 2)…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Correct Replacement Anti-Scuff Pads for a Yakima Mako Kayak Carrier

Continue Researching