How Would Hub Get Accessed When Dexter Disc Brake Kit # K71-635-2 is Installed
Published 03/29/2023
Question:
Am I interpreting correctly - in order to remove caliper to remove rotor to get to the hub, you need to remove the hydraulic cross over lines? Bearing inspection/maintenance requires cracking into the hydraulics therefore requiring a bleed afterward. Or is there a way to swing the whole caliper out of the way that I am overlooking?
asked by: Jeff D
0
Expert Reply:
A flexible brake line gets ran to the caliper of the Dexter Disc Brake Kit # K71-635-2 which allows it to swing out and a way if you needed to remove it and the rotor to access the hub's bearings.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Disc Brake Kit - 12-1/4" Rotor - 8 on 6-1/2 - E-Coat - 8,000 lbs
- Trailer Brakes
- Disc Brakes
- Standard Grade
- 8 on 6-1/2 Inch
- Rotor
- 8000 lbs Axle
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: What Size Hole Do I Drill In Bed For B&W Gooseneck Turnover Ball In 2026 GMC Sierra 2500 ?
- Q&A: How to Determine Wheel Offset
- Q&A: Availability of Wet Bolt Kit for 2024 Brinkley Z3610
- Q&A: Is There A Gooseneck Hitch To Fit An Aftermarket Puck System With No Gooseneck Ball?
- Q&A: Bearing Kit for Dexter 7k Axle on Fifth Wheel
- Q&A: Replacing Tandem Torsion Axles On a Bison Living Quarters Horse Trailer
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer