Rotation Rate For the Replacement Planetary Gearbox Kit For 10,000 lb. Bulldog Jacks

Question

Question:

Hello can you tell me how much reduction is low gear in ratio In rotation? Eg 3-1 or 2-1

asked by: Kenny L

1

Helpful Expert Reply:

The Replacement Planetary Gearbox Kit # BD500330 is a replacement part for 10,000 lb. Bulldog Jacks.

I have listed the rotation rates for the Replacement Planetary Gearbox Kit # BD500330 below:

- Low gear: full lifting power offers smooth and easy ratio of 1" every 27 turns

- High gear: ultimate speed with 1" for every 9 turns

expert reply by: Scott S

1

Answer 1

The Replacement Sungear and Subshaft for Bulldog 2-Speed Jack #BD500285 you will need to remove the gearbox cover with its 4 bolts. This will give you access to the planetary gears and this is basically the input part. I reached out to my contact at…

view full answer...

Answer 2

The part number that was provided is actually for the screen, #BVD0434-31, which is included with some Ventline roof vents. To obtain the part number for the fan you will need to remove the screen. I have attached a set of installation instructions…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 8

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Rotation Rate For the Replacement Planetary Gearbox Kit For 10,000 lb. Bulldog Jacks

Product Page this Question was Asked From

Continue Researching