Installation of Draw-Tite Class III Trailer Hitch on a 2009 Dodge Ram  

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

There are two possible replacement tarps for your FullTilt. If you have the cover with snaps you need the #EX5770. If you have the snapless version you need the #EX37770.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The instructions included with the Thule RV Wheel Levelers #TH307617 do state that the tires should be 20mm narrower than the width of the levelers for even support across the tires. That being said, these levelers are intended for motorhome use and…

Start by plugging in the brake control adapter #3020-P into the OEM harness located under the steering wheel, just to the right of the emergency brake pedal. Then find a place to mount the brake controller. It should be in a position that is easily…

If your 7-way says 'Mopar' on it, it should be the factory 7-way although it might have been a dealer installed instead of a factory installed option. Only vehicles with the factory installed tow package will have the blue under-dash…

The Brophy Camper Scissor Steps for truck campers, #AS04, are intended for an entry height of 31" to 40". If your camper door sets within that 31-40' range then yes this will fit your rig. Please see attached image for measuring points…

The Brophy Camper Scissor Steps - 4 Steps - Aluminum - Non-Slip Tread - 24" Wide - 300 lbs #AS24 will work well for your Lance 650 Camper as long as the height to your threshold is between 31 and 39 inches. If it is between 24 and 30 inches…