Clearance Lights that Can Fit 2006 Fleetwood Bounder 32W
Published 12/20/2022
Question:
Hi, Im looking to replace 5 lights and found these. I have a 2006 Fleetwood Bounder 32W. They appear to be the same roughly. My current ones are corroded and leaking. I noticed they are secured with 2 rivets, not screws. Im assuming I should drill those out to remove? Use new rivets? Additionally, both driver and passenger side marker/turn signal lights are in need of replacement. There is one on each side right under the side mirrors. I have been unable to locate a part for that. They are 5-1/4inch x 2inch approximately. Thanks for help finding the right products.
asked by: Jeff B
Helpful Expert Reply:
To remove rivets you will need to drill them out as there isn't any other way for them to come out. These Optronics Clearance or Side Marker Light - Incandescent # CB11WAB are pretty close to what you have now as they are 5-1/2 inches long by 2-3/8 inches wide. They aren't an exact fit but they should still work. I would recommend riveting on these too since that's what the old ones are held on with.
