Can the Snap Pad Jack Pad Be Used on a Travel Trailer Tongue Jack

Question

Question:

Can this item be used on the tongue jack of my travel trailer?

asked by: Daniel M

1

Helpful Expert Reply:

Yes, you can use the Snap Pad Jack Pad # SN97FR on your travel trailer tongue jack as long as it will fit. The Snap Pad Jack Pad # SN97FR fits a 5-1/2" round jack foot.

expert reply by: Scott S

1

Answer 1

Hi Carl; the saddle attachment on the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR is 3-1/4" wide at the base of it before the sides flare out. What will you be using the jack for?

view full answer...

Answer 2

The inner lip of the Snap Pad Jack Pad for Camper Jacks w/ 5-1/2" Round Feet #SN97FR that grips onto the jack foot has a 5-1/8" measurement from one edge to the other so you'd have a bit more than 1/8" of the lip covering the jack…

view full answer...

Answer 3

Hey Frank, We would need to know the diameter and shape of the footplate for your tongue jack in order to find the correct SnapPad to fit it.

view full answer...

Answer 4

Hey Mitch, thanks for reaching out. You’re right on target with your measurements. The SnapPad Mini Jack Pads #SN39FR, are made specifically for 5-1/2 inch square jack feet, so they’ll be a perfect match for the setup on your 2025 Trade Wind 23 FBT.…

view full answer...

Answer 5

Hey Mike! I checked with our contact at B&B Molding and found that the Replacement RV Plastic Check Valve with Clip for B&B Molders City Water Inlet #BM46MR is the correct replacement for your B&B Nautilus #BM43GR. This is the same as the…

view full answer...

Answer 6

Hello Donald, The Tandem Axle Teardrop Trailer Fenders for Enclosed Trailers – 15" to 16" Wheels – Qty 2 #CES74JR are constructed from 16-gauge nominal steel, offering a strong and durable solution for protecting your trailer from road…

view full answer...

Answer 7

There are plenty of people who have installed the HappiJac Camper Tie-Downs #LC182910-182971 over a bed-liner so you shouldn't have an issue. The only problem you could run into is the thickness of the liner might force you to source longer…

view full answer...

Answer 8

Hey Don, yes the Stromberg Carlson electric jack part #JET-3755 that you referenced would be a great option to replace the Lippert Smart Jack you have now. It uses the same mounting bracket bolt pattern so it will install easily and is a lot simpler…

view full answer...

Answer 9

The thickness of the Camco Cam Locks is measured from the bottom of the threads to the cam. I attached a diagram showing where we measure the thickness for your reference. Based on the photo of your Cam Lock, the Camco Cam Lock #CAM44323 will replace…

view full answer...

Answer 10

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

view full answer...

Can the Snap Pad Jack Pad Be Used on a Travel Trailer Tongue Jack

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching