What Type Of Hosing Is Needed To Install The JR Products Slide-Out RV Gravity Fill Inlet?
Updated 04/26/2022 | Published 04/25/2022
Products Featured in This Question
Question:
Can I attach 1/2inch pex to the vent fitting? If not, what is the recommended tube/hose to use for the vent hose? Thank you!
asked by: Ben
0
Expert Reply:
You can use standard PEX piping with the Slide-Out RV Gravity Fill Inlet with Lockable Latch # 37237525, or you can use hosing like the Valterra Braided PVC Tubing for RV Fresh Water # W01-1800 which will work with 1-1/4" - 1-3/8" diameter hoses, with the Valterra Hose Clamp # H03-0006.
expert reply by:
Bryce D
0
Product Page this Question was Asked From
Slide-Out RV Gravity Fill Inlet with Lockable Latch - Polar White
- RV Water Inlets
- Gravity Fill Inlet
- Recessed Mount
- 2-1/2 Inch Diameter Cutout
- 3-5/8 Inch Deep
- Plastic
- 3-1/2 Inch Diameter Flange
- Polar White
- JR Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Dimensions Of The Valterra RV Gravity Fill Water Inlet Funnel Opening
- Q&A: Which Toilet Floor Flange for 3 Inch Hub
- Q&A: Replacement B&B RV Gravity Water Inlet Hatch
- Q&A: Left-Hand Everchill 4.5 Cu Ft Stainless Steel Fridge
- Q&A: Recommended Jump Starter Pack for Work-Site Trucks
- Q&A: Can Dometic WH-6GEA Replace Atwood GC6AA-9E Water Heater
- Q&A: Replacement Atwood 75722 Motor for Atwood Camper Jack
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Converting Your RV Water Heater to Tankless