Do I Have to Cut into the Bumper of My 2022 Ford Explorer to Install the Draw-Tite # DT69MR?
Updated 03/25/2022 | Published 03/24/2022
Question:
Do you have to cut into bumper
asked by: Bob
0
Expert Reply:
Yes. You do have to cut into the bottom bumper fascia in order to install the Draw-Tite - 1-1/4" # DT69MR on your 2022 Ford Explorer. You also need to cut a 1.5" hole in the vehicle's heat shield. I went ahead and attached a photo from the installation manual that shows the required cutting on your vehicle. This is the same process for all of the hitches available for your vehicle
expert reply by:
Bob C
0
Required Cutting of Bumper Fascia and Heat Shield for # DT69MR
(click to enlarge)
(click to enlarge)
Continue Researching
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: Is Fascia Trimming Required on 2020 Ford Explorer to Install Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"