Removing The Tailgate With The Pop & Lock Tailgate Lock # PAL8450 Installed
Published 11/11/2021
Question:
I occasionally have to remove the tailgate. Do you know if the wiring will allow for easy removal from the vehicle? This is a general question as I have another truck that I may want to install this on also. That other truck I remove the tailgate frequently to load a slide in camper. Thank you,
asked by: Dan H
Expert Reply:
The Pop & Lock Custom Tailgate Lock - Power - Black # PAL8450 has a short wiring harness that will run through the tailgate and then under the bed to the frame and plug into the long wiring harness connector so as long as you mount the connectors is an easily accessible position under the vehicle it should only take a few seconds to unhook them and then remove the tailgate.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Hitch Anti-Rattle Devices: The Ultimate Guide
- Q&A: How to Pick Out Bearings for a Dexter P-21 SLR Axle
- Q&A: Troubleshooting A Pop & Lock Tailgate Lock Actuator That's Constantly Running On A Honda Ridgeline
- Q&A: Seal To Replace a Transcom 15191VB Oil Seal
- Q&A: Anti-Rattle Device For Weight Distribution System
- Q&A: Best Anti-Rattle For Towing & Ball Mount on 2 Inch Hitch
- Q&A: Channel Mount Trailer Coupler Alternative for 2-1/2" Channel
- Q&A: Trailer Wiring Harness and Mounting Brackets for a 2016 Nissan Frontier