Does etrailer Tongue Weight Scale for Campers and Utility Trailers # e99044 Need Calibration

Question

Question:

Can the scale be calibrated?

asked by: Morgan N

0

Expert Reply:

The etrailer Tongue Weight Scale for Campers and Utility Trailers # e99044 does not have the ability to be calibrated but would not need it.

expert reply by: Jameson C

0

Answer 1

You are correct that in the Blue Ox SwayPro Owner's Manual they do recommend use molybdenum grease on both the hitch ball and the spring bars. The LubriMatic Moly EP Grease #LM54FR in a grease gun, such as #L30480, will work well. You could use…

view full answer...

Answer 2

Both the Sherline Trailer Tongue Weight Scale #5780, and the etrailer Tongue Weight Scale #e99044 will accurately measure the tongue weight on your trailer as long as the tongue weight is less than 2000lbs. With that said I prefer the etrailer…

view full answer...

Answer 3

The Blue Ox SwayPro Weight Distribution w/ Sway Control #BXW1000 is only different from the Blue Ox SwayPro Weight Distribution w/ Sway Control #BXW1006 in the shank as you stated. The #BXW1006 has a much larger vertical adjustment ability. I've…

view full answer...

Answer 4

The etrailer Tongue Weight Scale part #e99044 will not be able to tell you the tongue weight of the setup when your weight distribution system is connected. There's only one way to tell how much tongue weight your weight distribution system is…

view full answer...

Answer 5

Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…

view full answer...

Answer 6

The B&W Continuum Weight Distribution System item #BW78FR weighs 116 lbs. The weight of the weight distribution system does not get added to your trailer's tongue weight. I have linked a review video below so you can see the features of this…

view full answer...

Answer 7

As there aren't any custom slide-on mirrors available for your vehicle, a universal towing mirror like the K-Source #KS3990 you'd looked at would be my recommendation. The dual lens set up gives you a larger field of vision than a single…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Does etrailer Tongue Weight Scale for Campers and Utility Trailers # e99044 Need Calibration

Continue Researching