Is the Footplate on the etrailer.com Trailer Jack e49ZR Removable?  

I do have a solution for you, however the Replacement Foot Pad #2500-3755G referenced in your question is designed specifically for certain electric jacks made by Stromberg Carlson so I cannot confirm if it will work well for your existing jack. For…

The outer diameter of this tube is 1-3/4 inches, if that matches the diameter of your old foot, this should work well for you. A snapper pin like #2500-26 is typically used to hold the foot in place.

Sounds like you have an issue with the nut and screw of the inner leg on your trailer jack. Typically this is a sign that it's time to replace the jack as it has an internal problem. I recommend replacing it with the Stromberg Carlson Electric…

Since you have a RAM brand a-frame powered jack the correct replacement foot is the part #EJ-3520-FT.

You can replace the leg on the Buyers Products 12v Electric Jack #3370093500 with the Replacement Footpad for Buyers Products 12v Electric Jacks #3373013261 .

The Replacement Foot for etrailer or Ram Electric Jacks #EJ-3520-FT has an inner diameter of about 1-1/2" and its outer diameter is 1-3/4" which is the measurement you'll need if you are looking for a replacement. This foot is designed…

We have a number of replacement parts for the Electric Jack w/ Footplate part #EJ-3520-BBX. I am not totally sure what you are referring to as the bottom plug but if it is the footplate, we have this available using the Replacement Foot for etrailer…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…