LED Replacement Bulbs For 2011 Toyota Venza And Hyperflashing
Updated 07/01/2021 | Published 06/26/2021
Products Featured in This Question
Question:
Does your LED blinker bulb actually work without hyper flash? In your video you show the installation but not the blinker working other than the hazard lights. Thank you for the feedback
asked by: MJ
Expert Reply:
Hyperflashing occurs because LEDs do not use resistance to create light, as a result this lower resistance is detected by the vehicle as a burnt out bulb. The 3156/3157 LED Turn Signal Bulbs - Wedge Base - 411 Lumens - Amber - Qty 2, part # ARC83FR, will work as a replacement bulb on your 2011 Toyota Venza with the addition of the Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2, part # DI34ZR.
I have included product description links and video review links below.
Product Page this Question was Asked From
3156/3157 LED Turn Signal Bulbs - Wedge Base - 411 Lumens - Amber - Qty 2
- Vehicle Lights
- Interior Light
- Tail Light
- Brake Light
- Dome Light
- Pair of Lights
- LED Light
- Replacement Bulb
- 3156
- 3157
- Amber
- ARC
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can LED Bulbs be Used in Gustafson RV Pendant Lights
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Installing Brake Controller on 1990 Ford F250
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Measurements of etrailer 2K Snap-Ring Swivel Trailer Jack
- Q&A: Overall Height of 2K Topwind Swivel Jack # TJBB-2001-B When Fully Retracted
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: Replacement 921 LED Bulbs for Interior Lighting