Where is this Draw-Tite 75607 made?
Updated 06/24/2021 | Published 06/22/2021
Products Featured in This Question
Question:
The other hitch you sell has a made in USA badge on it. Where is this made? Thats extremely important.
asked by: Paul
0
Expert Reply:
The Draw-Tite # 75607 is made in Mexico. If you are looking for a hitch that will fit your 2007 Chevy Colorado that is made in the US, you will want to go with the Curt # 13252. This is rated a little lower than the # 75607, but will still handle up to 4,000 pounds towing and 400 pounds of tongue weight.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: Frequently Asked Questions About Transmission Coolers
- Q&A: Replacement 4.4K Electric Brakes with Offset Mounting Bolt Pattern
- Q&A: Troubleshooting Hitch Bolts that Don't Want to Line Up Properly
- Q&A: Solution for Trailer Hitch Install Where Holes Don't Seem to Line Up Properly
- Q&A: Is Towing With A Hitch Better Than Towing With A Ball Mounted To Bumper
- Article: My Trailer Hitch Doesn't Fit
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure Your Trailer Wheel Bolt Pattern