Parts Needed To Install LED Lights 47-84-103 On 1989 Toyota Sunrader Motorhome
Question:
I have a 1989 Toyota Sunrader motorhome and would like to replace the tail light assembly with an LED setup. The existing setup is a Reflect-o-Lite Model #1400. The overall dimensions are approximately 21inch x 5 1/4inch so the Bargman 47-84-103 would not be a perfect fit. If I were to build a template to fit the Model 47-84-103 unit, would I need to replace my turn signal relay? Any other modifications required? Thanks!
asked by: Bern S
Expert Reply:
Since there is not an exact replacement for the Reflect-o-Lite Model #1400 lights you have on your 1989 Toyota Sunrader Motorhome you will need to modify or add a housing to make a different light fit.
Since the # 47-84-103 is an LED light you may need to add resistors # DI34ZR in the turn signal wiring to prevent hyper flashing. Other than that you will just need to make the housing for the light to fit in.
I included a video of the # DI34ZR for you to take a look at.
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Bargman LED Triple Tail Light - 5 Function - 36 Diodes - Black Base - Red and Clear Lens
- Trailer Lights
- Tail Lights
- Rear Reflector
- Stop/Turn/Tail/Backup
- Rectangle
- Recessed Mount
- Non-Submersible Lights
- LED Light
- 18L x 5-1/2W Inch
- Red and White
- Bargman
more information >
Continue Researching
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Is Bargman Triple, Long Tail Light # 47-84-103 A Pair or Sold Individually