Weight Distribution Shank that Can Provide 12 inches of Rise
Updated 04/12/2021 | Published 04/09/2021
Products Featured in This Question
Question:
I need to get a 2x2inch 12 to 13inch rise shank. It needs to have min 9inch long from center of pin lock hole to center of vertical adjustment holes.
asked by: Jerry C
0
Expert Reply:
We ALMOST have what you are looking for with the part # FA92-02-4315 which can do a rise of up to 12-1/2 inches but it's 1 inch too short in the length you are looking for as it is 8 inches from hitch pin hole to vertical adjustment holes. We don't have anything else that comes closer either.
expert reply by:
Jameson C
0
Continue Researching
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Comparing Reese Strait-Line and Curt TruTrack Weight Distribution Systems for 5,800 Pound Trailer
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Trying To Decide Between Reese Dual Cam II And Reese Strait Line
- Article: How to Measure for Trailer Hitch Drop
- Article: Determining Trailer Tongue Weight
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Comparing Reese Strait Line And Dual Cam II Weight Distribution Hitches
- Q&A: Installation Instructions for Reese Strait-Line Weight Distribution Systems
- Q&A: Comparing the Andersen Weight Distribution Systems To Friction Bar Systems
- Q&A: Instructions and Tools Needed to Install the Strait-Line Weight Distribution Hitch System # 66074
- Q&A: Fastway e2 Weight Distribution for 2025 Ford F-150 Towing Enclosed Trailer