Is the Reese Weight Distribution Shank Compatible with Convert-A-Ball Accessories

Updated 12/22/2020 | Published 12/17/2020

Products Featured in This Question

Convert-A-Ball Cushioned Weight Distribution Shank for 2" Hitches - 10,000 lbs

(28)

$164.98

Ball Mount Adapter for Convert-A-Ball Cushioned Weight Distribution Shank

(75)

$47.19

Clevis Adapter for Convert-A-Ball Cushioned Weight Distribution Shank - 10,000 lbs

(9)

$64.02

Pintle Hook Adapter for Convert-A-Ball Cushioned Weight Distribution Shank - 10,000 lbs

(8)

$51.72

Question:

What is the overall measurements of the vertical part as well as the measurements from top of horizontal part to bottom of vertical part. part with the 3/4inch pin holes. Will BA-1, CA-1, PA-1 from Convert-A-Ball mount to this hitch. Thank you

asked by: Harry F

Helpful Expert Reply:

For the Reese Weight Distribution Shank, part # RP3214, the overall length of the vertical shaft is 8-3/4", and the top of the horizontal shaft to the bottom of the vertical one is 7-1/2". I've linked to a video review of this shank for you to look at.

As this shank is for 2" receivers and has holes measuring 1-1/4" apart, the Convert-A-Ball Ball Mount Adapter, part # BA-1, that you mentioned will work just fine.

The Clevis Adapter, part # CA-1, and the Pintle Hook Adapter, part # PA-1, will not work with this shank. They are only compatible with the Convert-A-Ball Shank, part # AMAC1. This has the benefit of being compatible with all three, so it is probably the better option for you.

The Convert-A-Ball shank has greater rise and drop lengths than the Reese and a higher tongue weight capacity. The only downside to this one is that it has a lower gross towing capacity (only 10,000 pounds vs. Reese's 14,000 pounds). I've linked to a video review of this shank for you to look at.