Is a Fuse Needed for Center of Pin on Isolation Solenoid # PK5231201
Updated 08/31/2020 | Published 08/27/2020
Question:
What is the recommended fuse size for the 12v coming from the ignition switched side of the fuse box to the middle tap actuator of the solenoid for TR118665?
asked by: Gene H
0
Expert Reply:
It isn't necessary to run a fuse to the center pin of the Isolation Solenoid part # PK5231201 as this circuit simply closes the circuit between the two pins on the outside posts of the solenoid.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: How to Wire 12V Battery in Enclosed Trailer to Power Trailer Lights Independent of 7-Way Connection
- Q&A: Can I Disable Solar Charging on the Go Power PWM Solar Charge Controller w/ Bluetooth?
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Leaf Spring Bushings Closest to 1-1/4 Inch Outer Diameter
- Q&A: Picking Out Replacement Lens for Porch Light of 2018 Forest River Cherokee Grey Wolf 26DBH
- Q&A: Replacement Lens For A 2018 Grand Design Solitude 373FB Ova; Flood Light
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Powering Trailer Mounted Winch from 7-Way Trailer Connector
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How Many Batteries Do You Need to Run RV Air Conditioner?
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: How to Wire an Electric Winch