Can Wind Sensor for Awning be Added to 2020 Cougar 367FLS
Updated 08/25/2020 | Published 08/22/2020
Products Featured in This Question
Question:
We have a 2020 Cougar 367FLS with power owning, it is controlled through the touchpad or by controls on the outside on the arm. Will the module be enough ? Is it “plug and use” or do I need Smart Arms?
asked by: Gina G
0
Expert Reply:
The wind sensor part # LC715123 can be used on your 2020 Cougar 367FLS if the awning you have is a Solera Smart Arm. You mentioned a touch pad so if that touch pad looks like the part # LC717666 you'd have an awning setup that the sensor is compatible with.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: Everything I Need For a Complete 20 Foot Awning Kit
- Q&A: Can Rain and Wind Sensors be Added to Solera RV Awning
- Q&A: Does Solera Powered Awning Come with Everything to Replace Damaged Awning
- Q&A: Black Slide Topper Recommendations for 70, 154, and 144 Slide Outs
- Q&A: Can Solera Powered Awning Arms Be Replaced With Solera Smart Arm Conversion Kit?
- Q&A: Recommended Upgraded Motor for 5th Wheel Landing Gear
- Q&A: Replacement 15' Awning For Lippert Edge That Allows For Solera Screen/Family Room
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Stability Control for Heavy Duty Vehicles
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure a Trailer Axle
- Article: How to Install an RV Awning From Scratch
- Article: 7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money