Where Are Rear Fascia Tabs Located On Installation of Curt Hitch # C13046 on 2009 Subaru Tribeca
Updated 07/18/2012 | Published 07/15/2012
Question:
Where are the bumper fascia tabs? 2009 Subaru Tribeca
asked by: Chris H
0
Expert Reply:
When installing the Curt Class III 2 Inch Hitch, part # C13046, on the 2009 Subaru Tribeca the plastic fascia tabs will be located on the lower part of the bumper towards the corners. It will allow the plastic rear fascia to flex enough to allow the hitch to be installed to the bumper beam. I am including a link to the installation instructions on the Curt hitch, but it does not show where the tabs are located.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Fit of Husky 5th Wheel Hitch in Reese # RP30154 Picture Frame Adapter on 2013 Ram w/ Tow Prep Pkg
- Q&A: Benefits of Slider Hitch Over Andersen Ultimate Adapter AM3200
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Much Can a 2015 Subaru Forester Tow
- Q&A: Parts Needed To Tow With a 2008 Subaru Tribeca Hitch
- Q&A: What Size Locking Hitch Pin Fits Different Class Trailer Hitches
- Q&A: Where is Brake Controller Install Connector for 2022 Jeep Grand Cherokee 4xe
- Article: Hitch Adapters and Extenders
- Article: Best Hitches for Travel Trailers (2022) - For a Smooth, Sway-Free Ride
- Q&A: Compatibility of Curt Multipurpose Ball Mount with Hitch Height Adapter