How To Center The Steering Wheel After Installing Roadmaster Steering Stabilizer On Class A
Updated 09/11/2020 | Published 10/16/2019
Question:
After mounting this what adjustments are needed to center your steering wheel with this.
asked by: Larry H
0
Expert Reply:
The only way to center the steering wheel is to test drive it after installation. If the vehicle is pulling after you have installed the Roadmaster Steering Stabilizer part # RM-RBK4-RSSA then loosen the bracket U-bolts at the tie rod and re position it. Tighten the bolts and test drive it once again, repeating the process until the proper adjustment is achieved.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes
- Anti-Sway Bars
- Steering Stabilizer
- Mounting Hardware Included
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Adjust The Roadmaster Exact Center Steering Stabilizer For A More Comfortable Ride
- Q&A: Steering Stabilizer Recommendation for a 2013 Ford F-53 Motorhome Chassis
- Q&A: Universal Floor Mats For 2005 Thor Hurricane On Ford F53 Chassis
- Q&A: WeatherTech Mats for Newmar Baystar Class A Motorhome on Ford F-53 Chassis
- Q&A: Location of Brake Controller Connector 2016 Ford F53 Motorhome Chassis
- Q&A: Is Roadmaster TruTrac RM-TRACF53 For 1996 Ford F-53 The Entire Kit
- Q&A: Recommended Steering Stabilizer for a 2016 Forest River Georgetown XL 378TS
- Article: Best Vehicles to Flat Tow Behind an RV
Jim
9/8/2020
So, how does one re-position the ubolt bracket, right or left when the stabilizer is under spring tension?