Will Draw-Tite Class II Receiver Hitch # 36548 Fit a 2011 Dodge Charger R/T

Published 03/27/2012

Products Featured in This Question

Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(52)

$207.72

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(11)

$67.26

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2621)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2620)

$17.55

Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-3/4" Long - 3,500 lbs

(2328)

$34.99

Question:

Will this hitch fit on my 2011 Dodge Charger R/T?? Thanks

asked by: Josh

Expert Reply:

Any of the hitches we offer for the 2011 Charger will fit most models, including the R/T model. We have found that installing the hitch on dual exhaust models involves temporarily removing the muffler on the drivers side. On models that have dual exhaust tips on each side (for a total of 4), the muffler will be welded, instead of being clamped into place. This makes removing the muffler impossible, therefore the hitch CANNOT be installed.

If your Charger only has the single exhaust tip on each side of the vehicle, the Draw-Tite # 36548 you mentioned will work fine for you.

If you are planning on towing with your Charger, you might also need the following to complete your towing system:

Trailer wiring harness with 4-pole connector, # 118560
Ball mount, # 36061
1-7/8 inch trailer ball, # 19256
2 inch trailer ball, # 19258

To see the hitch install details, click on the provided link.