Is Fulton Wheel Assembly Compatible With Square Tube Jack

Question

Question:

Fulton F2 Wheel Assembly. I have a 2 inch square tube fitting with a removable flat plate. Will this removable wheel assembly fit into a SQUARE receiver not 2 inch ROUND tube steel?

asked by: Scott G

0

Expert Reply:

Due to the unique configuration of the Fulton Wheel Assembly # F500266, it would not be compatible with a square 2" jack; I am not aware of a caster wheel assembly that will fit a square 2" jack tube, mostly because those jacks have higher weight ratings which means they only use foot plates like what you said you have.

That means you would need to continue to use something like the Drop Leg with Foot # TJD-7000-FT which is 2" x 2" and has a 7,000 lb capacity.

expert reply by: Kyle S

0

click to enlarge

Answer 1

Hello Cash, thanks for reaching out. You are needing an A-frame jack, correct? We do have a good option for you, but there is not anything specifically designed for tailgate clearance. That said, I recommend the following: - etrailer Electric Trailer…

view full answer...

Answer 2

Hey Bill, The distance between all 3 bolt holes is 3" on center on the etrailer jack #e23ZV. If you were to remove the footplate from the jack the overall height would be 27-1/2", with the footplate it comes in at 29-1/2". What kind of…

view full answer...

Answer 3

You can get the Fulton F2 Adjustable A-Frame Trailer Jack #F1413250334 but take some measurements to see if it will fit in your A-Frame coupler. I've included a diagram for you! The plate that mounts to your A-Frame coupler is 5 inches in…

view full answer...

Answer 4

I spoke with my Fulton representative, who tells me that the Fulton #F1413250334 is set up to accept a wheel or a footplate, which will be held in by a snapper pin. If the jack doesn't have the collar with the pin hole, you must have a different…

view full answer...

Answer 5

Hello Izzy, thanks for reaching out. The necessary installation hardware will be included with the etrailer Electric Trailer Jacks like parts #e55ZV and #e23ZV. You can see the hardware pictured below. It is just 3 bolts that hold the A-frame jack to…

view full answer...

Answer 6

If they were talking about the hub face and spring center measurements then what was referred to was the hub-face-to-hub-face and spring-center-to-spring-center lengths. Hub face is measured from the base of one wheel stud to the base of the wheel…

view full answer...

Answer 7

For a Four Winns Boat Trailer with Titan Aero 6000 Surge Brake Actuator, I recommend replacement using the Titan Zinc-Plated, Leverlock Brake Actuator part #099-175-20 which is ready to go as is and will be a great fit. The reason I recommend…

view full answer...

Is Fulton Wheel Assembly Compatible With Square Tube Jack

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching