Recommended Trailer Hitch for a 1969 Chevrolet C10 with 8 Foot Bed
Updated 05/06/2019 | Published 05/05/2019
Products Featured in This Question
Question:
I am wondering if this receiver will fit i have a 1969 Chevy C10 8ft stepside bumper is 10inch below bottom of frame. Frame is 34inch wide will this fit i have my fuel tank under the frame as well.
asked by: Eric L
Expert Reply:
The Draw-Tite Trailer Hitch Receiver part # 40050 will only fit your 1969 Chevrolet C10 if it has the standard rear bumper which I have attached a photo of for you. If you have a different rear bumper which it sounds like you do then you will want to use the Draw-Tite Max-E-Loader Trailer Hitch Receiver part # 41504 instead.
If you can send me a photo of your rear bumper I would be happy to confirm the correct fit for you as well that way.
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Multi - Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Q&A: Hitch to Fit Older Vehicle with 34 inch Wide Frame
- Q&A: What Torque Should Be Used For U-Bolt Nuts On Trailer Suspension
- Q&A: Replacement For Lippert 175226/12656 4-Point Leveling Control Brain
- Q&A: Overall Width of Buyers Products Class 4 Service Body Long Hitch Receiver # 3371801055
- Q&A: Highest Capacity Bolt-On RV Hitch for National Class A Motorhome on Workhorse W-22 Chassis
- Q&A: Brake Controller Install on 2005 Chevy Workhorse Chassis
- Q&A: Which Draw-Tite Trailer Hitch Fits a Full Size 1988 Ford Bronco