Brake Controller Fuse Location in 2011 Dodge Ram 1500


What is to code fur trailer brake on a 5500 dodge ram 2011. trailer brake fuse.


Expert Reply:

The fuse location for an electric brake controller in a 2011 Ram 1500 is position J02 and it takes a 30-amp fuse. This is shown in the manual on page 564.

The part you referenced, T-One 4-Pole Vehicle Wiring Harness # 118384, is a basic wiring harness that carries only lighting signals but not brake power for a trailer. For a 7-way wiring set-up for your 2011 Ram 1500 that includes a trailer brake power circuit you can use kit # 74682. This plugs in to the factory wiring connector.

If you want to install a trailer brake controller like the Draw-Tite Activator # 5100 in a 2011 Dodge Ram 1500 with 4-pole wiring you will use part # 3021-P to plug the controller in under the dash and install kit # ETBC7.

expert reply by:
Adam R

Products Referenced in This Question

Product Page this Question was Asked From

Follow up Questions

What do you think?

* e-mail address format: [email protected]

I would like an email notification if someone replies to my comment

Similar Expert Q&A Pages

See More Q&A Expert Answers >>