What Portion of 1972 Ford Bronco Exhaust Does MagnaFlow Exhaust System # MF15344 Attach To
Updated 01/09/2019 | Published 01/08/2019
Question:
I need to know if this exhaustive system will bolt directly up to Stock ford Bronco manifolds This is a complete ground up restoration
asked by: Adam B
0
Expert Reply:
The MagnaFlow Crossmember-Back Exhaust System # MF15344 does fit your 1972 Ford Bronco but it would not bolt directly to the exhaust manifolds. It is designed to bolt up to an intermediate pipe that attaches to the manifolds. If you were looking for an excuse to install a set of headers this would bolt to them.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
MagnaFlow Crossmember-Back Exhaust System - Stainless Steel - Gas
- Exhaust Systems
- Crossmember-Back Exhaust
- Gas
- Dual
- 2 Tips
- 2-1/2 Inch Tubing Diameter
- Stainless Steel
- 2-1/2 Inch Tip Diameter
- Side Exit - Dual - Both Sides
- MagnaFlow
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch