Available Bolt-On Trailer Jacks
Updated 08/06/2018 | Published 08/03/2018
Products Featured in This Question
Question:
Is there any possible way to purchase a bolt-on version of tube mount BD500240? I prefer this swivel arrangement to any other, because if you weld it to the trailer with the pinhole vertical it is very failure resistant. It doesn’t rely on a spring, and when you a pin in a hole like that, if you don’t clip the bottom end it is still not very likely to jump up and out.
asked by: Joseph
Expert Reply:
The replacement jack pipe mounts we offer like Bulldog # BD500240 and # BD500339 are only offered in weld-on versions. We do have many bolt-on jacks that you can see on the linked page. These include items such as the Fulton Bolt-Thru Swivel Marine Jack with Dual Wheels # FXPD15L.
Product Page this Question was Asked From
Bulldog Replacement Pipe Mount for Swivel Jacks - 2-1/4" Male - Weld On - 5/8" Pull Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement Wheel Stud For a 2016 Kaufman 3 Car Wedge Trailer With 7,000 lb Axle
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Q&A: Pipe Mount Needed for 5K Bulldog Jacks
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Which Sidewinder Will Replace Lippert Rhino Pin Box
- Q&A: Can Sidewinder be Used to Replace Rhino Pin Box for Towing with 2022 Ford F-350 Super Duty
- Q&A: Is There A Replacement Pin Box For The Lippert Rhino Box
- Article: Where to Position the Trailer Axle?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Determining Trailer Tongue Weight
- Article: How to Wire an Electric Winch
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams