How to Pick Out Landing Gear for 1995 Aljo by Skyline 2975
Updated 05/30/2018 | Published 05/29/2018
Products Featured in This Question
Question:
Ive got a 1995 Aljo by Skyline 31foot model # 2975 wanting to know what jacks to get to replace.
asked by: Scott S
Expert Reply:
In order to pick out a direct replacement for the landing gear on your trailer we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Reese Tandem Landing Gear Set # RP500708. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and new ones installed.
I attached a picture that shows the dimensions that this landing gear set would fit with.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
The installs are pretty basic as long as the weld mounts match up like we talked about. If they don't you'd need to find someone to weld the legs on.
