Installation of Curt Class III Receiver on a 2007 BMW X3
Published 07/14/2011
Question:
can you view the installation instructions for the 2007 bmw x3 trailer hitch installation on line? Removal of rear bumper seems like it may be a problem yet installation time was fast?
asked by: Wayne B
Expert Reply:
You can view the install instructions by clicking on the link provided below or on the product description page.
The install is pretty involved, requiring the removal of the rear bumper fascia and bumper. The hitch actually replaces the bumper beam located behind the fascia. The fascia would then need to be trimmed as shown in the instructions before being replaced on the vehicle. When trimming the fascia, remember the old woodworkers credo: Measure twice, Cut once!
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended 4-Way Wiring Harness for a 2010 BMW X3
- Q&A: Replacement for Dimensions Unlimited Inverter Charger on Winnebago Tour
- Q&A: Recommended Battery Disconnect for a Flat Towed 2025 Chevy Trailblazer
- Q&A: Wiring Up a Harbor Freight 4-Way Trailer Connector and Trailer Lights
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Can the Yakima Rack and Roll be Used to Carry 2 Old Town Autopilot 120s
- Q&A: Replacement Wheels, Tires and Tubes For Yakima Rack And Roll Trailer