Pipe Mount Trailer Jack Recommendation to Replace Shelby Jack # 5754A
Published 01/04/2018
Question:
Looking to replace Shelby jack assembly to the matching welded on support. The model # reads 5754A and the rest if any is scratched off. 850# capacity. Need the correct O ring to snap in. Thanks
asked by: Rick S
1
Helpful Expert Reply:
We did have a customer come back and say that the Fulton jack part # FTJ120W0301 will attach just fine to the pipe mount on the trailer frame where a Shelby jack just like yours was installed.
expert reply by:
Jameson C
1
Continue Researching
- Q&A: Jack Recommendation to Replace Shelby Jack 5754A on Trailer
- Shop: Dutton-Lainson Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 12" Lift - Zinc - 1,000 lbs
- Q&A: Does a Trailer with Two 3,500 Pound Axles have a Gross Capacity of 7,000 Pounds
- Q&A: Trailer Hub Dust Cap with a 2.125" Outside Diameter
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Article: Best Boat Trailer Jacks
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Tire Sizing
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How To Read A Tire Sidewall
- Article: How to Measure for Trailer Hitch Drop