7-Way Bargmann RV Wiring Harness for Trailer Side
Updated 11/13/2017 | Published 11/12/2017
Products Featured in This Question
Question:
do you have this with stainless steel connectors? the brass corrodes and is difficult to clean. need 6 ft length.
asked by: Lynn F
0
Expert Reply:
Molded 7-way trailer connectors like the Bargman # 54006-009 always have the copper because of its electrical connection properties. The way to keep them from corrosion over time is to use dielectric grease # 11755. This keeps moisture, dirt, and debris out of your connections that can lead to corrosion. This grease actually assists in the electrical connections as well, so it is a help in both ways.
expert reply by:
Jason S
0
Product Page this Question was Asked From
7-Way Molded Trailer End with 6' Cable - HD Blue Insulated
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug and Lead
- Bargman
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Lighting Requirements
- Article: Most Popular Wheel Bearings
- Q&A: Stainless Steel Locking Hitch Pins For B & W Tow And Stow 2 1/2" Ball Mount
- Article: Trailer Maintenance Schedule
- Q&A: Difference in Brightness Between # BUL10CB Backup Light and # BUL72CB Utility Light
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Speed Rating of Kenda Karrier Tire
- Q&A: Upgrading 13" Tires And Wheels To 15" Tires And Wheels
- Q&A: Recommended 15 Inch Aluminum Trailer Wheel Rated for at Least 2,100 Pounds
- Q&A: Recommended Hanger Spacing for Triple Axle Trailer
- Q&A: Why is There a Wire Color Differnce Between 7 Way Traditional vs RV Standard