What is the Radius of the Handle on the Fulton Square, Fixed-Mount Marine Jack # FHD2500
Updated 06/30/2017 | Published 06/29/2017
Question:
I need the measurements of the handle please. what is the outside radius when you use it? Thanks.
asked by: Craig M
0
Expert Reply:
The radius of the handle on the etrailer Square Jack w/ Footplate # MJSQ-2500B measures right at 7-7/8 inches.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Fulton Square, Fixed-Mount Marine Jack - Drop Leg - Sidewind - 30" Lift - 2,500 lbs
- Trailer Jack
- Boat Trailer
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Marine Grade
- 2001 - 3000 lbs
- Manual Jack
- 30 Inch Lift
- Bolt-On
- With Rectangle Foot
- Fulton
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: Will a Taller Drop Leg Fit Fulton 2.5K Square Fixed-Mount Marine Jack FHD2500
- Q&A: Does Grease Seal # 34823 Feature a Garter Spring
- Q&A: 12 Volt Accessory Circuit Relay Location in 2019 Ford F-250
- Q&A: Troubleshooting Weak Trailer Brakes That Won't Lock Up with Override Lever of Controller Slid
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Solution for Brake Actuator on 3-1/2" Trailer Tongue
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle