Compatibility of the Voyager Rear Camera and LCD Monitor on a 1999 Chinook RV

Updated 06/27/2020 | Published 06/28/2017

Question:

I have an Audiovox LCM-445 LCD 4inch monitor in my 1999 Chinook RV...with a non-functioning I think AOC-75 b/w camera. Will the VCMS20 color camera work with this monitor? I have the 4 pin connector to the existing camera.

asked by: Roxanne

Expert Reply:

The connection on the Voyager Rear Camera with LED Low Light Assist, # VCMS20, uses the standard 4 pin audio/video connection. If your monitor uses this type of audio/video connection, then the two cables will connect.

The only issue I might see is that with the age of your monitor you may not be able to utilize all the features of the new camera. However, standard operation of the system will function well.

If you are looking for a complete upgrade, I recommend the Rear View Safety Backup Camera System, # RVS-770613-NM. This system will include a 7 inch digital color LCD monitor and features a camera that is equipped with a 50 foot view in infrared night vision that makes backing up at night a lot easier.

expert reply by: Jared P

Israel B.

6/21/2020

I have an 2001. Chinook concourse. My back up camera.. no longer works. Can I replace the camera with a newer model and can I used the same wiring harness. My screen is installed in my driver side visor?

Chris R.

6/24/2020

Most camera systems use their own harness, so it's hard to say without knowing what particular model camera setup your Chinook is equipped with. Is there any brand or model info printed on the existing camera?

Israel B.

6/24/2020

@ChrisR where can I find the four pin connect ? the camera is a voyager back up, serial # is. 106C0001. Model is very hard to read due to wear and Tate. All I can copy is the following, model one of the two numbers are as follows , AOG or AGC-10.manufacturer in Pueblo Colorado. It has a four pin connector and one long black wire with a slide connector. Thanks for the help.

Israel B.

6/25/2020

@ChrisR the camera is a voyager back up, serial # is. 106C0001. Model is very hard to read due to wear and Tate. All I can copy is the following, model one of the two numbers are as follows , AOG or AGC-10.manufacturer in Pueblo Colorado. It has a four pin connector and one long black wire with a slide connector. Thanks for the help.