What Size Hole Is Needed For Installation Of Optronics Flush Mount 4 Inch Round Light # STL23R-24B
Updated 03/02/2011 | Published 02/28/2011
Products Featured in This Question
Question:
I would like to install these flush mount tail lights and need to know the diameter of the hole. Will a 4 hole saw provided the needed holes size or does it need to be slightly larger? My application was previously surface mount lights but I am changing over to these recessed lights and need to know how big to make the hole since there are no installation instructions.
asked by: Chris
Expert Reply:
If you are using the Optronics Rubber Grommet for 4 Inch Round Trailer Tail Lights, part # A45GB, with the Optronics Sealed, 4 Inch Round LED Trailer Stop, Turn and Tail Light, Flush Mount, part # STL23R-24B, you will want to drill a 4-1/2 inch cutout. This grommet will allow you to flush mount 4 inch round lights to your trailer.
If you are needing the wiring for the light I have both a right angle pigtail and a straight pigtail available. The Optronics Right Angle 3-Wire Pigtail, part # A47PB, is the right angle pigtail and the Optronics Straight 3-Wire Pigtail, part # A45PB, is the straight pigtail.
