How Does Brake Controller Install in 2012 Chevy Suburban

Question

Question:

Do you have vehicle specific plug in adapters for trailer brake controllers for Chevy suburbans 2012-current? No hard wiring just plug and go for suburbans?

asked by: Trevor

0

Expert Reply:

No plug is present under the dash of your 2012 Chevy Suburban, but the needed wires are already run. You will connect the brake controller wiring with the vehicle wiring already present under the dash.

Check out the install video I attached that shows the P3 part # 90195 being installed in a similar GM SUV as yours.

expert reply by: Jameson C

0

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 4

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 5

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 6

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 7

Hey Katja, the Curt Echo Mobile brake controller part #C51180 would be your best option. This is a wireless brake controller and all it requires is a 7-way with the taillight functions and the 12 volt accessory circuit active and you'd be set. So…

view full answer...

Answer 8

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 9

Hey Dave, the install harness part #3063-P does fit to the green connector that is under your seat in your 2025 Mercedes Benz Sprinter 4500 and would work great with the P3 part #90195 which is widely considered to be the best controller around. I…

view full answer...

Answer 10

There isn't anything like an autonomous controller that would step up if the factory controller fails. I'd simply bypass the existing factory brake controller. The GM ITBC, although it works better now than the earlier models has been…

view full answer...