Do I Modify My Auto Level Housing to Install a Draw-Tite Hitch # 36309 on my 2000 Buick Le Sabre
Updated 11/24/2010 | Published 11/23/2010
Products Featured in This Question
Question:
When installing this on a 2000 Buick Le Sabre Im not sure what modifications need to be done to the auto load leveling control unit, if any.
asked by: David H
Expert Reply:
In order to install this Draw-Tite Receiver Hitch, part # 36309, you will need to remove the rearmost fastener which secures the load leveling control housing to the frame rail and discard it. You will then trim the load leveling control housing around where the previously removed fastener was. See the picture to the right for further clarification.
Some other items you may need:
Draw Bar # 36063
Ball # 19258 or 19256
Trailer Wiring # 119176KIT
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Rooftop Cargo Carriers
- Q&A: Ground Clearance of a 2004 Buick LeSabre with a Draw Tite Hitch Installed
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Hitch Fit for 2000 Pontiac Bonneville
- Q&A: How Does Trailer Wiring Install on a 2008 Saab 9-3
- Q&A: Method for removing and Installing Tang-Style Spindles Washers
- Q&A: Should Rear Bar Sit Higher Than Front Bar on Yakima Roof Rack System for 2017 Honda Pilot
- Q&A: 2006 Saab 9-3 Aero with Dual Exhaust Trailer Hitch Compatibility
- Q&A: Trailer Hitch Classes Available for a 2003 Buick LeSabre
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Attach a Cargo Carrier to a Roof Rack