Could Switch be Used to Power Two of the 18-1/4" x 12" Holding Tank Heater Pad 277-000164
Published 11/01/2016
Question:
Can you run more than one heating pad through one dc switch
asked by: Jason C
0
Expert Reply:
As long as the switch can handle the amperage load of two of the heating pads part # 277-000164 yes it would be fine. This heating pad draws 4.8 amps. So the switch would need to be able to accommodate 9.6 amps.
The part # D16740 would easily handle the amperage.
expert reply by:
Jameson C
0
Continue Researching
- Video: All You Need to Know About the Spectro 14-Gauge ATO-ATC Fuse Holder
- Video: Let’s Check Out the Spectro 12-Gauge ATC-ATO Fuse Holder
- Video: Universal-Design Rocker Switch Spec Review
- Search Results: 14 gauge wiring
- Search Results: in line fuse
- Search Results: insulation
- Q&A: How to Connect Fuse to ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat
- Q&A: Recommended Toggle Switch For For ThermaHeat RV Holding Tank Heater Pads
- Q&A: Will The Hopkins EasyLift Tailgate Lift Assist Fit A 2012 Ford F-250
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Q&A: Does The ThermaHeat RV Holding Tank Heater Pad Require Special Wiring
- Q&A: Can Thermaheat Tank Heater Pad Be Insulated Over
- Shop: Spectro 14-Gauge ATO-ATC Fuse Holder - Qty 1
- Shop: Replacement In-Line Fuse Holder for Curt Wiring Harness - Qty 1
- Shop: 14 Gauge Primary Wire - Red - per Foot
- Shop: 14 Gauge Primary Wire - Black - per Foot
- Shop: Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 4-Blade - Red Pilot Light
- Shop: Single Rocker Switch - Labeled On/Off - SPST - Black
- Shop: Derale Lighted On/Off Switch for Electric Fans