Are Additional Springs or Mounting Brackets Needed for Solera Awning # LCV000231446
Updated 09/28/2016 | Published 09/27/2016 >
Products Featured in This Question
Question:
Is this thing spring loaded and does it have mounting brackets?
asked by: Roland R
Expert Reply:
Hello Roland,
Awning # LCV000231446 is the fabric and roll bar only but you would not need to add any additional springs. I spoke with my Solera contact and she said that with # LCV000231446 you will also need one the following:
Manual hardware kit # LC434727 (requires 69" unobstructed from the awning rail down where it would mount. This also requires a minimum clearance of 2 1/2" from awning rail to top of entry door. These arms are a flat top and only pitch 3/4", however do have an auto dump feature (all awnings have this). The auto dump is when 10lbs of water is atop the awning, it auto dumps to prevent the fabric from sagging).
Product Page this Question was Asked From
Replacement Roller and Fabric Kit for 17' Solera Power and Hybrid RV Awnings - Solid Black
- RV Awning
- Patio Awnings
- Extends 8 Feet
- Fabric/Rollers
- 17 Feet Wide
- Black
- Solera
more information >
Continue Researching
- Q&A: Replacement GE Air Conditioner for a ARC15AACBL2
- Q&A: Replacement Small Gear for Kwikee 25 Series Step Motor
- Q&A: Troubleshooting A Furrion Range/Oven Knob That's Always Lit Up Red
- Q&A: Dimensions Of Jack Motors On Lippert Ground Control 3.0 LC358590
- Q&A: Replacement 17' Awning Fabric And Roller Kit For A 2011 Keystone Cougar
- Q&A: Replacement Lid/Dome for MaxxFan 4751KS
- Q&A: Replacement Awning Fabric
- Article: Converting Your RV Water Heater to Tankless

