Selecting Correct Ball Mount for Use with Class II Hitch on 2010 Dodge Avenger  

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

Yes, you'll need to have the hitch ball torqued to your ball mount. The torque ratings will vary depending on the hitch ball size and weight capacity but generally these ratings are a bit higher and the manufacturer will let you know what the…

The Tow Ready 2 Inch Hitch Ball, part #63845, of the ball mount kit part #989900 you have referenced needs to be torqued to 250 foot pounds. The size of socket or wrench needed to tighten that would be a 1-1/2 inch and then for the diameter of the…

The 2" Hitch Ball like the #A-90 requires a foot pound torque of 450 but I would really need to know your specific ball to tell you the torque rating. An impact wrench is the preferred installation method but if you don't have access to…

Since the manufacturer can change the torque specs you will want to look at the instructions link, to the right, which is always up to date even if the manufacturer makes a change. I have also included a link to a video showing installation for you.…

The correct ball mount or draw bar for the Hidden Hitch Class I 1-1/4 Inch Hitch, part #24812, on your 2010 Toyota Matrix will be Draw-Tite Ball Mount, part #3593. When towing with a Class I or Class II trailer hitch, the ball mount that is…

The torque specifications for the nut on a hitch ball will be based on the diameter of the shank. The Tow Ready Interchangeable Hitch Ball Set part #63803 has a 1" diameter shank so the recommended torque specification for the nut is 250 ft.…

The nut of the Tow Ready Hitch Ball part #63845 that you referenced needs to be tightened to 250 ft lbs of torque regardless of what vehicle/ball mount it is used with.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…