What is the Purpose of the Shims that Come with the Bak Revolver X2 Tonneau
Updated 02/19/2016 | Published 02/18/2016
Question:
It is somewhat unclear if I have to remove the spacers on the rails that are factory revolver x2 installed. after readjusting the clamps higher on the rails I was able to get the cover to fit better, but it is still is very tight, not sure if I should remove the cover and remove the spacers?
asked by: Rick A
Expert Reply:
I spoke to my contact at BAK and his response was:
Shims are on there to make the rails sit flush on the bed rails and make them narrow enough for the cover. If they are interfering then they can remove them or relocate them to where the rails are sitting flush and narrow enough to have the cover secure.
Product Page this Question was Asked From
BAK Revolver X2 Hard Tonneau Cover - Roll Up - Aluminum and Vinyl
- Tonneau Cover
- Roll-Up - Hard
- Rack Compatible
- Opens at Tailgate
- Tailgate Lock
- Flush Profile - Inside Bed Rails
- Aluminum and Vinyl
- Vinyl Grain
- BAK Industries
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Lift Motors For A Fan-Tastic Vent Motor 6010-05
- Q&A: What is the Hitch Pin Size on the Hitch for a 2017 Toyota Tacoma
- Q&A: Total Weight of Thule EasyFold XT 2 Electric Bike Platform Rack TH903202
- Q&A: Which Roof Rack Allow Me To Mount A Paddle Board On A Camper Shell?