Hole Saw Size Recommendation for Installing the Draw Tite Hitch 24832
Updated 10/12/2015 | Published 10/11/2015
Question:
2010 Mazda 6 What size metal hole saw bit is used to create the access/mount hole in the frame member for Draw-Tite 24832?
asked by: Rob J
0
Expert Reply:
The recommended size hole saw to use to install the Draw Tite hitch part # 24832 is 1-1/8 inches.
I also attached a link to the install instructions and video for this hitch for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will Draw-Tite Trailer Hitch, # 24832, Fit on a 2009 Mazda 6 with Single Exhaust
- Q&A: Will Curt Wiring Harness Operate Correctly When Installed on a 2023 Mazda CX-30
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Microwave To Replace Discontinued Dometic DOTR12CBIV
- Q&A: What Is The Difference Between The Tekonsha # TK62VR And # 118811 T-One Vehicle Wiring Harnesses
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Trailer Hitch Receiver For 2005 Mazda 3