Recommended Replacement Bearing Kit For Dutton-Lainson Electric Clutch Winch
Updated 07/17/2015 | Published 07/16/2015
Products Featured in This Question
Question:
My electric strong arm wench has worked great for the past five years. However, lately it stops pulling the last few feet up the trailer. Motor is running but it wont pull boat while on ramps incline. I have to drive up to level ground to pull the last few feet. Suggestions?
asked by: Steve C
Expert Reply:
It sounds like the thrust bearings may be bad on your Dutton-Lainson TW400 StrongArm Electric Winch, part # DL25200.
I have attached the installation instructions and in the instructions there is an exploded view of the winch and its components. My contact at Dutton-Lainson told me that they are 99 percent sure the thrust bearings are bad. We do have a replacement kit that includes the bearings, the washers and a retaining clip. That kit is part # DL6381.
This kit should take care of the problem with the winch failing to pull the last few feet.
Continue Researching
- Shop: Replacement Brake Spring Kit for Dutton-Lainson StrongArm Winch
- Video: Breaking Down the Replacement Brake Spring Kit for Dutton-Lainson StrongArm Winch
- Q&A: Spring and Ratchet Repair Kits for Dutton-Lainson Hand Winch
- Q&A: Replacement Brake Disc and Brake Spring Kit For A Dutton-Lainson StrongArm Winch SA12015DC
- Shop: Replacement Thrust Bearing Kit for Dutton Lainson Electric Clutch Winches
- Q&A: Replacement Brake Spring Kit for Dutton-Lainson StrongArm Winch # DL25215
- Shop: Replacement Brake Disc Assembly for Dutton-Lainson StrongArm Electric Winch
- Shop: StrongArm Electric Winch - AC Powered - 1,200 lbs